Zeck Audio STAC Force180 Installationsanleitung PDF herunterladen (Seite 8)

Rev. 1.00 12-02-13 8/41

12045 Concurrent Dynamic IP Configuration (DIC) removes default gateway

DIC protocols addressed in this ticket: DHCP, PPP

A problem related to concurrent DIC client has been fixed.

If a SmartNode was configured for being DIC client on several IP interfaces it could happen that

the default route applied through one interface got spuriously removed. It is still true that the

SmartNode is only able to handle one default route received through a DIC protocol. However,

now a default route can only be removed by the IP interface which has previously applied it.

Consider the following rules:

 Last applied route wins, overwriting is allowed.

If a valid default route is already applied through a DIC protocol and the SmartNode

receives a new valid route, then the existing route will be replaced.

 Removing only possible through „owner‟ interface.

If a default route has been applied through one interface and was overwritten by a

second different interface, it can then only be removed again by the second interface

(owner). If for example a „link down‟ occurs on interface one, this has no impact on the

default route because it has been applied by interface two.

12055 Flash hook on FXO interface broken

The flash hook behavior was broken on FXO interfaces. In fact the interface would hang in the

flash hook state and ignore any subsequent events on that interface. This has been corrected.

Build Series 2012-07-18

11497 Configuration option for caller-ID checksum verification on FXO interface

A new configuration option on the interface FXO lets the user configure if the checksum of the

caller-ID should be verified or ignored. Depending on the configuration and the presence of a

valid checksum the caller-ID information is forwarded or discarded. See details in the New

configuration commands section.

11728 G.SHDSL interface: service-mode auto-detection

Now it is possible to configure the SmartNode to detect the G.SHDSL line mode automatically.

It is able to detect whether it is connected to a 2-wire or a 4-wire line. Note that this feature only

works if G14 release or later is installed to the G.S interface. Refer to the section New

Configuration Commands for a detailed description.

11811 ISDN status errors on Web UI

All the ISDN capable network ports (BRI, E1T1) showed a DISPLAY_CMD error on their status

page on the Web UI. This problem has been fixed and the related ISDN information is

appearing again.

11835 MWI on FXS not working

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

Keine Kommentare

Zeck Audio STAC Force180 Installationsanleitung Seite 8